Asynchronous Replication - American Megatrends StorTrends User’s guide User Manual

Asynchronous Replication

These commands configure asynchronous replication.
Command Argument
create asyncreplica -t/--type <sar/jar/hasar>
-n/--name <snap assisted replication name>
for HA-DR)
percentage>
Example: Single volume in CG
172.16.70.70 -s c1 -r v1 -m 172.16.70.153 -c 6 -z
10 -e asyncreplica
Example: Multiple volumes in CG
-i 172.16.70.70 –s c1 -r v0 –r v1 -r v2 -m
172.16.70.153 -153 -c 6 -z 10 -e asyncreplica
delete asyncreplica -n/--name <asynchronous replication name>
-c/--containername <container name>
-d/--index <system assigned name>
-f/--force(optional)
Example:
get asyncreplica -n/--name <asynchronous replication name>
-c/--containername <container name>
-d/--index <system assigned name> (optional)
-s/--compressionstats (optional)
Example:
list asyncreplica -c/--containername <container name>
-f/--volumedialect
-a/--primarycontainer <primary contName>
-l/--primaryvolume <primary volName>
-i/--primaryip <primary host IP address>
-s/--secondarycontainer <secondary contName>
-r/--secondaryvolume <secondary volName>
-m/--secondaryip <secondary host IP>
-k/--hasecondaryip <HA secondary host IP> (Only
-z/--secsnapcount <secondary snap count>
-c/--compression <zlib compression
level>(optional)
-e/--encryption (optional)
-b/--dedup (optional)
-w/--wds <bandwidth in mbps> (optional)
-u/--utilization <bandwidth utilization in
(optional only if wds enabled)
create -t sar -n name -f 1 -a c0 -l v0 -i
create –t sar –n name -f 0 –a c0 -l v0 -l v1 -l v2
delete -n name -c c0 -d 1 asyncreplica
delete -n name -c c0 –d 1 -f asyncreplica
get -n name -c c0 -d 1 asyncreplica
Description
Creates a asynchronous replication
pair. Both the primary and
secondary volumes should be
present before this operation.
Note:
1) Volume Dialect
[0] - ISCSI
[1] – NAS
2) Compression Type
[0] – No compression
[1 - 9] – levels
3)
secsnapcount can take values
between 1 to 1022
4)
WDS mode is used only in Snap
Assisted Replication and HA-DR
5) This command can be issued
only in the storage system that will
be the Primary.
6) HA-DR (hasar) option can be
used only after HA is established
across all volumes of the DAR
(DR) group.
7) The HA secondary host IP is the
WAN IP of the HA pair which can
be reached from the SAR (DR)
secondary system.
Deletes the asynchronous
replication pair
-f/--force flag is optional and is
used where asynchronous
replication has to be deleted
forcefully
This command can be issued only
in the storage system that will be
the Primary.
Displays the asynchronous
replication details.
This command can be issued on
both Primary and Secondary
storage systems.
Lists available asynchronous
replication pairs in the given
Chapter Two: Command Set 33