Table of Contents
Advertisement
Chapter 2
Command Set
The CLI design being similar to the DMTF SMASH specifications follows the standard to a great extent. The
commands supported can be represented grammatically as follows:
<verb> <option> ... <property> <target>
The CLI provides a wide range of command sets. These commands are grouped into modules for better
understanding. Each command is non-interactive and state-less. The <options> are supported using switches.
Our CLI accepts both short and long options for each switch to make it user-friendly. If there is any error in
the parameters entered, the CLI will display the usage of that particular command.
CLI also provides extensive online help. Each command supports a help option using '-h' or
'--help' that will display the grammar of the command.
To get the main list of targets or modules present in CLI, the user should type the command "main" at the
CLI prompt.
The following targets will get displayed:
*****************************************************************
-----------------------------------------------------------------
1. ug
3. dir
5. dump
7. ndmp
9. iscsi
11. quota
13. volume
15. health
17. network
19. eventlog
21. firewall
23. timezone
25. sysupgrade
27. asyncreplica
29. snapvalidation
For more information on the targets please use the following command
show -t/--target <targetname>
Note : Targetnames are case insensitive
Example :
show -t iscsi
*****************************************************************
The show option can also be used to show commands based on <verb>, and to display the list of targets or
verbs available.
Command Set
TARGET LIST
2. ups
4. srm
6. raid
8. alert
10. share
12. system
14. domain
16. license
18. journal
20. protocol
22. datetime
24. serverinfo
26. syncreplica
28. recoverywizard
Chapter Two: Command Set
7
Advertisement
Table of Contents
