Ups Configuration - American Megatrends StorTrends User’s guide User Manual

UPS Configuration

These commands configure the UPS for power management.
Command Argument
get UPS -i/--info
-x/--xml
get UPS -i/--info
-m/--monitor
-x/--xml
set UPS -d/--disable
-x/--xml
set UPS -e/--enable or
-d/--disable
-b/--battery <min battery value>
-t/--timeout <mins>
-m/--mode {1}
-x/--xml
For example: set –e –b 10 –t 3 –m 1 ups
set UPS -e/--enable or
d/--disable
-b/--battery <min battery value>
-t/--timeout <mins>
-m/--mode {2}
-i/--masterip <{HostName/Master Ip>
-x/--xml
For example: set -e -b 35 -t 300 -m 2 -i 10.0.0.218
ups
config UPS -i/--info
-x/--xml
config UPS -l/--list
-x/--xml
config UPS -d/--driver <num>
-p/--port <value>
-x/--xml
For example: config –d 2 –p 1 ups
Description
Displays the existing UPS
configuration.
Display the monitoring
configuration for the configured
UPS devices.
Disables automatic shutdown.
Sets the UPS configuration to
given values. The enable mode is
to denote the shutdown option.
Timeout should be given in
minutes. Battery is the minimum
battery value below which the
shutdown is triggered Mode checks
whether it set to master or slave.
Note:
Minimum Battery value should be
between 0 and 100 %
Timeout value should be between
0 and 1000 minutes
Sets the UPS configuration to
given values. The battery value
indicates the minimum battery
value at which the alert has to be
generated. Timeout should be
given in minutes. Mode is set to
slave and the masterip is IP
Address of the master.
Note:
Minimum Battery value should be
between 0 and 100
Timeout value should be between
0 and 1000
Displays currently configured
driver for UPS monitoring.
Displays list of available drivers.
Sets driver to use with UPS
monitoring.
Driver number is from list obtained
from –list command.
Port value:
1 – COM1
2 – COM2
u - USB
Chapter Two: Command Set 29