High-Voltage Power Supply (Hvps) Assembly Removal - Lexmark C540 Service Manual

High-voltage power supply (HVPS) assembly removal

See "High-voltage power supply" on page 7-7
Note: This removal requires a magnetized, long-shank Phillips screwdriver at least 8 in. or 200 mm long.
1.
Remove the top cover assembly. See
2.
Remove the rear shield. See
3.
Remove the cable cover (A).
4.
Disconnect the high-voltage power supply (HVPS) cable at the HVPS and at the controller board.
for the part number.
"Top cover assembly removal" on page
"Rear shield removal" on page
4-12.
4-11.
Repair information
5025-2xx, 4xx
4-31