High Voltage Power Supply (Hvps) Card Removal - Lexmark W850n Service Manual

High voltage power supply (HVPS) card removal

1.
Remove the front left cover. See
2.
Remove the top cover assembly. See
3.
Remove the PC cartridge.
4.
Remove the printer front door assembly. See
5.
Remove the front inner cover. See
6.
Disconnect the connector from the HVPS card assembly (A).
7.
Release the harness from the clamps.
8.
Remove the two screws securing the HVPS card assembly (A).
9.
Remove the HVPS card assembly (A) by sliding it outward in the direction of the arrow.
Note: Before reinstalling, ensure the HVPS (A) is inserted into the side slots properly.
"Printer front left cover removal" on page
"Top cover assembly removal" on page
"Printer front door assembly removal" on page
"Front inner cover removal" on page
Clamp
A
4-10.
Front
Clamp
4024-110
4-3.
4-7.
4-8.
Connector
4-115
Repair information
Previous
Next
Go Back