USB port connector removal
See
"USB port and cable (for portable flash drive)" on page 7-8
The FRU includes the USB port connector and cable.
1.
Remove the operator panel. See
2.
Remove the right cover assembly. See
3.
Remove the waste toner bottle. See
4.
Remove the rear shield. See
5.
Remove the rear screw (A) in the waste toner bottle sensor contact to allow access to the cable cover.
Note: The waste toner bottle sensor contact does not need to be unplugged or removed.
6.
Remove the four screws (B) from the cable cover.
7.
Disconnect the USB port cable (C) from the controller board.
"Operator panel removal" on page
"Right cover assembly removal" on page
"Waste toner bottle removal" on page
"Rear shield removal" on page
for the part number.
4-9.
4-10.
4-60.
4-11.
Repair information
5025-2xx, 4xx
4-59