Lexmark 632n - T B/W Laser Printer Service Manual page 57

4060-xxx
User attendance messages (continued)
Primary message
Reattach
Bins x–y
Reattach
Envelope Feeder
Reattach
Output Bin x
2-24
Service Manual
Secondary message Explanation
Bins x–y=Bins 1 to 5, Bins 2 to 6, or Bins 6 to 10
This messages displays for the following conditions:
• The specified output bins may have been removed
from the printer, possibly to clear a paper jam or to
remove the option.
• The option(s) may be attached to the printer but a
communications problem may prevent the printer
from detecting the option. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to
service check" on page
This messages displays for the following conditions:
• The feeder may have been removed from the
printer, possibly to clear a paper jam or to remove
the option.
• The feeder may be attached to the printer but a
communications problem may prevent the printer
from detecting the option. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to
service check" on page
Bin x=Bin 1, Bin 2, or Bin 3
This messages displays for the following conditions:
• The specified output bin may have been removed
from the printer, possibly to clear a paper jam or to
remove the option.
• The option may be attached to the printer but a
communications problem may prevent the printer
from detecting the option. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go
service check" on page
"Input tray(s)
2-64.
"Envelope feeder
2-49.
to"Output expander
2-72.