Lexmark 632n - T B/W Laser Printer Service Manual page 53

4060-xxx
User attendance messages (continued)
Primary message
Check Duplex
Connection
Check Tray x
Connection
Close Finisher Side
Door
Close Finisher Top
Cover
Delete All Jobs
Go/Stop?
2-20
Service Manual
Secondary message Explanation
This messages displays for the following conditions:
• The duplex option may have been removed from
the printer, possibly to clear a paper jam or to
remove the option.
• The duplex option may be attached to the printer
but a communications problem may prevent the
printer from detection. For example, there may be a
poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to
service check" on page
Tray x=Tray 2, Tray 3, Tray 4, or Tray 5
This messages displays for the following conditions:
• The specified device may have been removed from
the printer, possibly to clear a paper jam or to
uninstall the option.
• The option may be attached to the printer but a
communications problem may prevent the printer
from detecting the option. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to
service check" on page
Close the finisher side door. If the message does not
clear automatically when the door is closed, go to
"StapleSmart finisher service check" on page
Close the finisher top cover. If the message does not
clear automatically when the cover is closed, go to
"StapleSmart finisher service check" on page
When the user has selected the Print and Hold Delete
All Jobs selection, this message is displayed. The
following actions may be taken:
• Press Go to confirm the selection. All jobs are
deleted.
• Press Return or Stop to cancel the delete
operation.
"Duplex option
2-47.
"Input tray(s)
2-64.
2-86.
2-86.