4060-xxx
Low voltage power supply removal
CAUTION: Unplug the printer before you begin.
1.
Remove the right side cover. See
2.
Remove fuser assembly. See
3.
Remove the LVPS mounting screws (A) from the rear of the bottom pan.
4.
Pull the LVPS assembly far enough out from the right side of the printer to disconnect the fuser
lamp cable.
Warning: The LVPS assembly may be difficult to remove from the printer. Do not use
4-42
Service Manual
"Right cover removal" on page
"Fuser assembly removal" on page
excessive force in the removal.
A(203)
4-10.
4-23.