Panasonic Toughbook CF-19KDRAXCM Service Manual page 43

n Assembly of the Pad PCB and SW PCB
(Note) Arrow without specified measurement: 0 ~ 0.5 mm
PAD PWB ASSY
PAD MAIN FPC Ass'y
PAD-Main FPC
Fold back
0
Tape
n Putting of the TP Bottom Tape
Front side
Screw
9.2.8. Setting the left LED PCB and right
LED PCB
1. Connect the Cable to the Connector. (CN806)
2. Fix the left LED PCB.
3. Connect the Cable to the Connector. (CN801)
4. Fix the right LED PCB.
5. Attach the two Release Papers.
6. Attach the Palm Rest Ass'y.
PAD PWB
SW FPC
PAD MAIN FPC ASSY
No direction when inserting
Insert
Stiffening Plate Side
0 1mm
1mm
SW PCB Ass'y
Match to the upper left corner. 0 to 0.5mm
Back side
Power Cable Cushion
Wrap around the Cable.
Use the fixing JIG for stressed
parts when inserting.
SW PCB Ass'y
Operation Tape
Match the edge
and attach it.
Ensure the LED part does
not come off or run over.
Release Paper
left LED PCB
Connector(CN806)
right LED PCB
9-20
LED(R) FPC
Insert
Power SW Cable
Insert
8 2mm
Confirm the direction
when attaching.
CN bracket is on the
back side.
SW PCB
Operation
Sheet
Confirm the direction when attaching.
Screw
Release Paper
Connector(CN801)