Panasonic Toughbook CF-19KDRAXCM Service Manual page 38

n Assembly of LCD Hinge
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
n Line Processing of Antenna Cable and LCD Cable
Step1
Lock Spring
Install the Lock Springs on the
Hinge as shown in figure.
Step2
Lock Plate Ass'y
Install the Lock Plate on the Hinge
as shown in figure.
Initial condition of LCD Hinge.
Avoid running over the
rib and boss to avoid
The direction which can rotate
catching the Cable
when the Hinge is set.
Torque of tightening screw(No. 2) :0.8 0.08N m( 8.0 0.8kgf cm)
Lock Plate Ass'y
Lock Plate Ass'y
Step3
Install the Hinge Cover Assy on the
Hinge as shown in figure.
Step4
Direction of rotation
Rotate the Hinge part to the arrow
direction as shown in figure.
If attached reversely,
the direction of cutting
edge faces the Cable
and this may damage
the Cable. Be careful
of the direction.
Cable Hold Plate
S2
Screw
LCD Hinge
LCD Cable Protector
Attach to the bottom face of the Lock Plate.
0~2mm
Step5
LCD Rear Side
Hinge Cover Ass'y
LCD Cable Holder
Fit the Holder to the Hinge Cover after inserting cables
into the Cable Holder as shown in figure.
9-15
S3
Ensure the "C" side
comes to the lower
right corner when
viewing from above.
Screw
The position of the Antenna cables:
Black/White/Blue/Gray/Brown or Green
(From the left)