Panasonic Toughbook CF-19KDRAXCM Service Manual page 34

n Assembly of LCD Back Damper (Application Model : Digitizer Model)
<Note>
*Paste Sheets firmly. 20~30N(2.0~3.0Kgf)
<Order of fixing screws>
0~1mm
Tape
Paste
LCD Side Cushion
Attach between the ribs
on the side of Frame.
The form of the left and
the right isn't symmetrical.
LCD PWB Spacer
Insert this between
LCD PCB & LCD Farme.
Screw the Board and the
Spacer together.
n Assembly of LED PCB
Insert the tip of LED Plate Holder
to the LCD Frame.
1 3mm
Attachment Standard
LED PCB ASSY
LED PCB
LCD Back Cushion DA
LED PCB ASSY
After inserting the
connector, slide the
hook to lock
Screw
LCD BACK
Cushion
Screw
LCD Side Cushion Lower
0 0.5mm
Torque of tightening screw :0.16~0.20N . m(1.6~2.0kgf . cm)
Cross section A-A'
Insert the upper part of Digitizer Assy to the Plate.
LED PCB
Sheet
Match to the center from
right and left to attach (± 1 mm).
A
A'
Digitizer PWB ASSY
Attach #12 on LCD PWB Spacer.
Fit to the
corner.
0~1mm
LCD BACK LCD BACK
Cushion Cushion
Fit LED Plate Holder
to the LCD Frame.
Insert the LED PCB to the
LED Plate
Pin of the LCD Frame.
Holder
Tape
Paste Tape after set the LED PCB,LED Plate Holder
9-11
Digitizer ASSY LCD Back Plate DA
LCD Back Plate DA
Insert to the Digitizer as illustrated above to attach.
Fit to the top edge of Plate.
0~0.5mm
Screw
Screw
Screw the Board and the
Spacer together.
LCD BACK
Cushion
Fit to the corner. Fit to the corner. Fit to the corner.
0~1mm
LCD BACK Cushion
LCD Side Cushion Lower
LED PCB
Insert LED PCB to
the LCD Frame.