Tray Mapping - Xerox 6100BD - Phaser Color Laser Printer System Manual

Tray mapping

System Guide
Tray Confirmation options:
• None - No tray confirmation pop up. The system assumes
tray refill, but if tray attributes change, the tray will fault. To
clear the fault modify the programming to match the tray. In
addition, the "New Stock has been Loaded" option must be
selected.
• When Tray Settings Change - A tray confirmation pop up
appears every time a stock attribute changes.
• After Every Tray Cycle - A tray confirmation pop up
appears every time a tray is opened and closed, or the
Printer reports a new stock attribute.
• Auto Accept Settings Changes - This mode will
automatically update the tray programming on the Xerox
FreeFlow Print Server to match what is reported by the
Printer. This option is not available on Nuvera C/P.
NOTE: Only System Administrators can set Tray Confirmation
options.
NOTE: Tray confirmation is not available on iGen3 with Xerox
FreeFlow Print Server.
The Xerox FreeFlow Print Server allows the operator to select and
save tray mappings for recurring jobs or for jobs needing the same
mapping.
From the Printer GUI, the operator selects [Save Mapping]. The
dialog box [Save Settings] enables the user to either select an
existing mapping or create a new mapping by assigning a name
and entering a description in the Comments input area. The
operator can also delete mappings.
To apply the saved mapping to another print run, the operator
accesses the Save Settings dialog box, selects the desired saved
setting and selects [OK]. This action reprograms all the trays to
the values previously stored.
Finishing
4- 5