Saving Stock And Tray Mappings - Xerox 6100BD - Phaser Color Laser Printer Getting Started Manual

XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING STARTED
2. Type mount /XRXbackup to mount the backup
3. Type cd /XRXbackup.
4. Copy or ftp the backup files to the /XRXbackup
♦
If it is desirable to store the system backup files to tape,
refer to the Tools and Utilities section of this document for
the TGBackup procedure.
♦
When restoring a system backup, a DocuSP System
Restore CD is provided with the software kit to your Xerox
Service Representatie. Performing the following to start
the Restore procedure:
1. Insert DocuSP System Restore CD in the CDROM
2. Shutdown the DocuSP controller by selecting
3. At the ok> prompt, type boot cdrom.
4. During the system restore process, a series of
♦
If a system restore is being performed following a fatal
disk failure or replacement of the hard disks, a DocuSP
clean install must be performed first to partition the hard
drives and create the partitions. Following the clean
install, copy the backup files to the /XRXbackup partition
then perform the system restore.
♦
For a configuration backup, do not use the /XRXbackup
partition to store the configuration files. The configuration
backup files can be stored on the DocuSP internal disk,
an external disk, an NFS mounted network drive, or
supported media such as a floppy drive or CDROM R/W.

Saving stock and tray mappings

DocuSP 4.1 now provides the ability to save the current paper
tray programming to a file and recall that file for later use. The
saved tray mappings may also be copied to another DocuSP-
based system using the DocuSP Backup and Restore
functionality.
For example, if a job or series of jobs that are often run have a
specific paper tray programming, the mapping can be saved and
recalled for faster setup for printing of the job.
This functionality is not available on the DocuColor iGen3.
partition.
partition from the storage location.
drive.
Shutdown from the DocuSP user interface.
questions displays asking if you wish to create a new
file system. Enter yes.
DOCUSP 4.1
11