Pcl Offset/Separator/Subset Finishing Command; Pcl Offset Stacking; Using The Pcs Separator - Xerox 6100BD - Phaser Color Laser Printer System Manual

PCL offset/separator/subset finishing command

PCL Offset Stacking

Using the PCS Separator

System Guide
The use of the PCL separator command, <ESC>&l1T, in
combination with Xerox FreeFlow
enables subset finishing for PCL jobs. The PCL separator
command defines offset segments of a job. PCL does not
commonly support finishing. However, the use of the PCL
separator command allows offset segments of a job to be finished
based on the finishing default set on the queue. For example, if
the queue default is portrait stitch, all segments of a job where the
PCL separator command has been used will be stitched.
The placement guidelines are as follows:
• Current Page Offset: If the current page is to be offset from the
previous page, then the PCL separator command must be
placed on the current page before any image data. Placement
should be within the job/page control section or before.
• Next Page Offset: If the next page in the document is to be
offset from the current page, the PCL separator command
must be placed at the end of the current page after any image
items.
Access the Offset stacking switch by opening Printer Manager and
selecting the Stacking tab and then select [Offset Stacking].
To enable offset stacking for collated or uncollated jobs, select the
enable checkbox. Both buttons are located under the collated
stacking and uncollated stacking sections.
The following information should be considered when using the
PCL separator command:
• The offset switch in Printer Manager in the Xerox FreeFlow
Print Server software must be set to ON. If the offset switch is
set to OFF and a job with the PCL separator command is
received, the sets will not offset when the job is printed.
• Multiple uses of the PCL separator command within a job will
be honored.
• Multiple uses of the PCL separator command on a page will be
ignored.
• All finishing limitations and restrictions at the printer will apply
to a subset segment.
Print Server queue defaults,
®
Finishing
4- 3