Replacing An Expansion Board; Removing An Expansion Board - HP DL360 - ProLiant - G3 Setup And Installation Manual

Replacing an Expansion Board

To install an expansion board, complete the procedures described in the following
subsections.

Removing an Expansion Board

The expansion board and PCI riser board assembly must be removed to replace an
expansion board.
CAUTION: To avoid damaging the system or expansion boards, remove all AC
power cords before installing or removing an expansion board. When the front panel
power switch is in the Off position, auxiliary power is still connected to the PCI
expansion slot and may damage the card.
1. Access internal server components. Refer to the "Accessing Internal Server
Components" section earlier in this chapter.
2. Disconnect any cables leading from any existing expansion board in the system
board.
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
2-9