Installing Hot-Plug Hard Drives - HP DL360 - ProLiant - G3 Setup And Installation Manual

Installing Hot-Plug Hard Drives

To install a hot-plug hard drive:
IMPORTANT: The ProLiant DL360 Generation 3 server supports HP universal U320 drives
only. The Compaq branded Ultra3 or HP branded U160 hot-plug drives are not supported.
NOTE: If installed, remove the hard drive blank from the server.
1. Slide the hard drive into the open bay (1).
2. Close the drive latch to secure the hard drive into the server (2).
Figure 2-10: Installing a hot-plug hard drive
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
2-15