HP DL360 - ProLiant - G3 Setup And Installation Manual page 90

Table D-3: Server Does Not Have Video
WARNING: To reduce the risk of electric shock or damage to the equipment,
before opening access panels to reseat components, power down the server, and
then disconnect the power cord.
Note: For LED locations and functions, as well as switch setting information, refer to Appendix E,
"LEDs, Switches, and Jumpers."
Possible Reasons
Video may not be properly connected.
Switches may not be correctly set on the system
board.
If an optional video board was installed, the
monitor cable may not be correctly connected.
The monitor may be connected to the wrong
video connector.
Expansion boards or DIMMs may not be
properly connected or seated.
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
The Next Step
1. Confirm that the monitor has power and
that the monitor cable is securely
connected. If more than one video adapter
is installed, make sure that the monitor is
connected to the correct video board.
2. Confirm that the monitor is functional by
connecting it to a known working server.
3. Confirm that the switch settings on the
system board are correctly set.
4. Power down the server. Reseat all
expansion boards and DIMMs, and then
reseat all cable connections.
5. Restart the server.
Troubleshooting
continued
D-7