HP DL360 - ProLiant - G3 Setup And Installation Manual page 95

Troubleshooting
Table D-4: Problems After Initial Startup
Problem Possible Cause
Hard drive controller
order is incorrect.
Encountered problem
after new hardware was
added to the system.
Problem was
encountered with
hardware added to a
system with a
factory-installed
operating system.
Note: Refer to Chapter 4, "Server Configuration and Utilities," or refer to the ROM-Based Setup
Utility User Guide, for complete instructions on the use of RBSU.
D-12
Writer: Richard O. Heath File Name: i-appd Troubleshooting.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/11/02 11:23 AM
continued
Possible Solution
Run RBSU by pressing the F9 key and correct
this problem.
Refer to the documentation provided with the
hardware.
Remove the new hardware.
The factory-installed operating system software
installation must be completed before adding
new hardware to the system.
Be sure that all instructions provided in the HP
Factory-Installed Operating System Software
Installation Guide are being followed.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL