HP DL360 - ProLiant - G3 Setup And Installation Manual page 24

c. Move to the front of the rack and loosen the thumbscrews securing the server
in the rack (1).
d. Grasp the front panel thumbscrews, and extend the server from the rack. The
cables remain clamped in the cable tray. The rail release latches engage
automatically.
e. Press in and hold the rail release latches (2).
f.
Holding the rail release latches, extend the server until the latches clear the
rack.
g. Pull the server completely out of the rack and set it on a flat, level
surface (3).
Figure 2-3: Removing the server from the rack
h. Remove the access panel. Refer to the "Removing the Access Panel" section
earlier in this chapter.
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
2-5