Enterasys C5G124-24 Configuration Manual page 55

Table 4-1 Default Settings for Basic Switch Operation (continued)
Feature
Password history
Policy classification
Port auto-negotiation
Port advertised ability
Port broadcast suppression Enabled and set to limit broadcast packets to 14,881 per second on all switch
Port duplex mode
Port enable/disable
Port priority
Port speed
Port trap
Power over Ethernet port
admin state
Priority classification
RADIUS client
RADIUS retries
RADIUS timeout
Rate limiting
Security mode
SNMP
SNTP
Spanning Tree
Spanning Tree edge port
administrative status
Spanning Tree edge port
delay
Spanning Tree forward
delay
Spanning Tree hello
interval
Spanning Tree ID (SID)
Spanning Tree maximum
aging time
Spanning Tree port priority
Spanning Tree priority
Default Setting
No passwords are checked for duplication.
Classification rules are automatically enabled when created.
Enabled on all ports.
Maximum ability advertised on all ports.
ports.
Set to half duplex, except for 100BASE-FX and 1000BASE-X, which is set to
full duplex.
Enabled.
Set to 0.
Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps, and
100BASE-FX, which is set to 100 Mbps.
All ports are enabled to send link traps.
Administrative state is on (auto).
Supported only on switches with PoE.
Classification rules are automatically enabled when created.
Disabled.
When the client is enabled, set to 3.
When the client is enabled, set to 20 seconds.
Disabled globally and on all ports. (Available only on A4 switches.)
Normal.
Enabled.
Disabled.
Globally enabled and enabled on all ports.
Edge port administrative status begins with the value set to false initially after
the device is powered up. If a Spanning Tree BDPU is not received on the
port within a few seconds, the status setting changes to true.
Enabled.
Set to 15 seconds.
Set to 2 seconds.
Set to 0.
Set to 20 seconds.
All ports with bridge priority are set to 128 (medium priority).
Bridge priority is set to 32768.
Factory Default Settings
Fixed Switch Configuration Guide 4-3