Figure 89. Making Six-Drive Hot Swap Drive Cage Backplane With Expander Connections (Dp/Ws/Brp Configuration Shown - Fan Bracket Not Shown In The Illustration For Clarity) - Intel S3210SHLC - Entry Server Board Motherboard User Manual

Hot Swap Drive Cage Upgrade Install Instructions (optional)
d. If you are installing a SAS/SATA hot swap backplane with expander
Warning: SATA controllers cannot be used with an expander backplane.
i. Connect the two power cables (see letter "A" in the following figure) to the
ii. Connect a SAS/SATA data cable (see letter "B") to each appropriate SAS/
iii. Connect the IPMB cable (see letter "C").
iv. Connect the fan power to the server board. For the Intel® Server Board
A
Figure 89. Making Six-drive Hot Swap Drive Cage Backplane with Expander
Connections (DP/WS/BRP configuration shown - fan bracket not shown in the
18. Install the hot swap hard drives. For instructions, see
SCSI hot swap drive
19. Install the front bezel assembly. For instructions, see
Assembly".
20. Install the left side cover. For instructions, see
21. Plug all peripheral devices and the AC power cable into the server.
72
power cable connectors on the SAS/SATA backplane.
SATA connector on the SAS/SATA backplane.
S5000VSA, use FAN1. For other Intel® server boards, refer to the Quick Start
User's Guide that came with the server board.
C
B
illustration for clarity)
cage:".
Intel® Entry Server Chassis SC5299-E UP/DP/WS/BRP User Guide
AF00448
"If you are installing a six-drive
"Installing the Front Bezel
"Installing the Left Side Cover".