Installing The Processor Air Duct; Installing Or Removing A Server Board; Figure 17. Installing Processor Air Duct - Intel S3210SHLC - Entry Server Board Motherboard User Manual

Hardware Installations and Upgrades

Installing the Processor Air Duct

Note: The following procedure is not applicable to the UP configuration of the Intel
Server Chassis SC5299-E. The processor air duct on the UP configuration is built into the
left side cover. Removal of the left side cover will also remove the attached ductwork.
Note: The following procedure is not applicable to the DP/BRP configuration of the Intel
Server Chassis SC5299-E if you have an Intel® Server Board S3000AH installed.
Warning: DO NOT operate the server chassis without the processor air duct in place. The processor
air duct is required for proper airflow within the chassis.
1. Lower the processor air duct into the chassis and line it up with the two mounting
holes in chassis. Secure the processor air duct to the chassis with two mounting
screws.
2. Install the left side cover. For instructions, see
3. Plug all peripheral devices and the AC power cable into the server. Power up the
server.

Installing or Removing a Server Board

Note: The type of Intel
model of chassis you purchased. For a breakout of server board/chassis model
compatibility, see
Configurations".
To install or remove a server board, do the following:
1. Observe the safety and ESD precautions listed in
20

Figure 17. Installing Processor Air Duct

®
Server Board you can install in your chassis will depend upon the
Table 1, "Breakdown of Intel® Entry Server Chassis SC5299-E
Intel® Entry Server Chassis SC5299-E UP/DP/WS/BRP User Guide
TP01137
"Installing the Left Side
Appendix A, "Safety
®
Entry
®
Entry
Cover".
Information".