Printer Receives A Blank Fax - Lexmark X5450 User Manual

Check the Dial Prefix
setting
10
11
12
Check Speed Dial
number
Be sure that printer is
detecting a dial tone

Printer receives a blank fax

Check original
Check ink
1
From the control panel, press Fax Mode.
2
Press .
3
Press or repeatedly until Fax Setup appears.
4
Press .
5
Press or repeatedly until Dialing and Sending appears.
6
Press .
7
Press or repeatedly until Dial Prefix appears.
8
Press .
9
To change the setting, press
Press .
Enter the prefix to be dialed before each telephone number.
Press .
•
Check to make sure Speed Dial has been programmed for the number that you wish to
dial. See "Setting up Speed Dial using the computer" on page 60.
•
As an alternative, dial the telephone number manually.
•
See "Sending a fax while listening to a call (On Hook Dial)" on page 57.
•
Check the Dial Method setting.
1
Listen for a dial tone. If you hear a dial tone but the printer hangs up without dialing,
this means it did not recognize the dial tone.
2
From the control panel, press Fax Mode.
3
Press .
4
Press or repeatedly until Fax Setup appears.
5
Press .
6
Press or repeatedly until Dialing and Sending appears.
7
Press .
8
Press or repeatedly until Dial Method appears.
9
Press .
10
Press or repeatedly until Dial Behind PBX appears.
11
Press to save this setting.
Ask the sender to verify the original document was loaded correctly.
Check the ink levels, and install a new print cartridge if necessary.
Troubleshooting
or repeatedly until Create appears.
133