Remote Control Code; Laser Pointer Function; Pointer Function - Sanyo PLC-XU116 - 4500 Lumens Owner's Manual

Part Names and Functions
This remote control emits a laser beam from the laser light window. Press the LASER button to activate the
laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is
pressed for more than one minute or if it is released, the laser light goes off.
The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or
other people. The following is the caution label for the laser beam.
CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure. Never look directly into the laser light window while a laser
is emitted, otherwise eye damage may result.
Signal Emission Indicator
Laser Light Window
You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the
projected image.
1
Press and hold the MENU and the NO SHOW buttons
for more than 5 seconds to activate the Pointer function.
(The Laser pointer has switched to the Pointer function.)

Press the LASER button on the remote control
pointing toward the projector. The Spotlight or Pointer
is displayed on the screen with the LASER button
lighting green. Then move the Spotlight or Pointer with
the PRESENTATION POINTER button. If the LASER
button does not light green and continues to emit a
laser beam, try the abovementioned procedure until
the LASER button lights green.
3
To clear the Spotlight or Pointer out the screen, press
the LASER button pointing toward the projector and
see if the LASER button lighting is turned off.
To switch to the Laser pointer again, press and hold
the NO SHOW and MENU buttons for more than 5
seconds or slide the RESET/ON/ALL-OFF switch to
RESET and then to ON.
When you reset the Pointer function, the remote
control code will be reset, as well.
Spotlight
 Note:
You can choose the size of Spotlight (Large/Middle/
Small) and the pattern of Pointer (Arrow/Finger/Dot) in
the Setting Menu. See "Pointer" on page 54.
14

Laser Pointer Function

The caution label is put on the remote control.

Pointer Function

Pointer
PRESENTATION POINTER
button
MENU button
NO SHOW button
Press and hold the MENU
and NO SHOW buttons for
more than 5 seconds.
PRESENTATION POINTER
button
LASER button
After the Laser pointer has
switched to the Pointer, use
the LASER button as the
Pointer function ON-OFF
switch. Press the LASER
button pointing toward the
projector and see if it lights
green.