Sanyo PLC-XU116 - 4500 Lumens Owner's Manual page 49

Auto setup
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP/
CANCEL button on the top control or the AUTO SET/CANCEL
button on the remote control. Settings for those functions can
be altered as follows:
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point ▲▼
buttons to select one of the following options.
Off ......Input search will not work.
On 1 ...Input search works under the following situation.
– When pressing the AUTO SETUP/CANCEL
button on the top control.
– When pressing the AUTO SET/CANCEL button
on the remote control.
On  ...Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET/CANCEL button
on the remote control.
– When pressing the AUTO SETUP/CANCEL
button on the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC adj .
On . . . . . . Enables Auto PC adjustment when pressing
the AUTO SET/CANCEL button on the remote
control or the AUTO SETUP/CANCEL button
on the top control.
Off . . . . . . Disables Auto PC adjustment.
Auto Keystone
Auto . . . . Always works and corrects keystone
distortion according to the projector's tilt.
Manual . . Works only when pressing the AUTO SETUP/
CANCEL button on the top control or the
AUTO SET/CANCEL button on the remote
control.
Off . . . . . . Disables Auto Keystone.
Note:
•While Input search is set to On 1 or On , the status of Input
and Lamp are displayed every time the signal is switched.
•Only the last selected input source can be detected.
•If the INPUT button on the top control or the COMPUTER,
VIDEO or NETWORK buttons on the remote control is pressed
during Input search is in progress, Input search will stop and go
back to the previous input signal.
• Input search, Auto PC adj . and Auto Keystone can not be
set Off at the same time.
Auto setup Menu
Note:
• Auto Keystone corrects vertical distortion only, not
correct horizontal distortion.
• The Auto Keystone function can not work when the
Ceiling is set On in the Setting menu (p.54).
• Perfect correction of the image distortion can not
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP/CANCEL button, adjust manually
by pressing the KEYSTONE button on the remote
control or selecting Keystone in the Setting menu
(pp.27,50).
• Fine sync, Total dots, Horizontal and Vertical of
some computers can not be fully adjusted with the
Auto PC adjustment function. When the image is
not provided properly with this operation, manual
adjustments are required (pp.35-36).
Setting
49