Attaching The Lens Cap; Cleaning The Projection Lens; Cleaning The Projector Cabinet - Sanyo PLC-XU116 - 4500 Lumens Owner's Manual

When moving the projector or while it is not in use, replace
the lens cap.
1
Thread the string through the hole on the lens cap and
then tie a knot in the string to secure it in place.
2
To pass the other end of the string into the hole on the
top of the projector and pull at it.
Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning cloth that
contains a small amount of non-abrasive camera lens
cleaner or use a lens cleaning paper or commercially
available air blower to clean the lens.
Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents or other harsh chemicals might scratch
the surface of the lens.
Unplug the AC power cord before cleaning.
Gently wipe the projector body with a soft dry cleaning cloth.
When the cabinet is heavily soiled, use a small amount of
mild detergent and finish with a soft dry cleaning cloth. Avoid
using an excessive amount of cleaner. Abrasive cleaners,
solvents or other harsh chemicals might scratch the surface
of the cabinet.
When the projector is not in use, put the projector in
an appropriate carrying case to protect it from dust and
scratches.
CAUTION
Do not use any flammable solvents or air sprays on the projector and in its vicinity. The explosion or
fire hazard may occur even after the AC power cord is unplugged because the temperature inside the
projector is extremely high due to the lamps. In addition, there is a risk that the internal parts may be
damaged not only by the flammable air spray but also by the cold air.

Attaching the Lens Cap

Cleaning the Projection Lens

Cleaning the Projector Cabinet

Maintenance and Cleaning
Lens Cap
String for the lens cap
Secure it to the hole
Hole
with a screw.
65