Wireless Mouse Operation; Remote Control Code - Sanyo PLC-XT30 Owner's Manual

Wireless Mouse Operation

The remote control can be used as a wireless mouse for your computer.
1 Before operating the wireless mouse, connect
your computer and the projector with the
supplied USB cable. (See page 22 for
connection.)
When the Pointer function is used, the
wireless mouse is not available.
2
When a USB cable is connected to the
computer and the projector, turn on the
projector first, then the computer. If you turn
on the computer first, the wireless mouse
function may not operate properly.

Remote Control Code

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See "Remote control" in the Setting Menu on page 57.
1 Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes.
2 To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to "RESET," and then to "ON."
The initial code is set to Code 1.
Part Names and Functions
PRESENTATION POINTER
button
Move the pointer on the screen
with this button.
R-CLICK button
Acts as right (click) mouse
button while the projector and a
computer are connected with a
USB cable.
L-CLICK button
Acts as left (click) mouse
button while the projector
and a computer are
connected with a USB
cable.
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than five seconds to switch between
the codes.
MENU button
Number buttons
RESET/ON/ALL OFF
Switch
17