10.4 Client Router
In the Client Router Mode, the ENH202 has DHCP Server build inside that allows many LANs
automatically generate an IP address to share the same Internet. Connect an AP/WISP
Wirelessly and connect to LANs via wired. Client Router Mode is act completely opposite to
the AP Router Mode.
Please refer to the last section to check Access point's configuration.
Client Router
Step1
Step2
Step3
Step4
Step5
Step6
Step7
Step8
Step9
Client Router's IP setting must match to the Access Point's subnet.
Login to the web-based configuration interface with default IP
192.168.1.1
Select your country or region's regulation.
Select Operation Mode to Client Router from System
Properties.
Change your Local Area Network setting to Obtain an IP
Address Automatically.
Use site survey to scan Access Points that are available in nearby
area.
Select the AP you would like to associate with.
Setup the authentication settings that match to the Access Point's
setting.
Setup your WAN connection type given by your Internet Service
Provider from WAN Settings.
Press Apply to process all the configurations.