About This Document - EnGenius ENH202 User Manual

This document is written by EnGenius Inc. EnGenius Inc. has rights to change any of this
document without notice and all rights reserved. This document can only be used for guiding
the configuration setup of EnGenius products.
This document is to demonstrate the EnGenius ENH202 Wireless Access Point & Client
Bridge. Please read the document carefully before setup the ENH202. If the damage is caused
by the inappropriate behaviors, the repair will not be included in the warranty.
Formats
This document uses following symbols to indicate and highlight special message.
Caution: This symbol represents the Vital message and it could be harmful for
the device or settings.
Note: This symbol represents the important message for the settings.
Tip: This symbol represents the alternative choice that can save time or
resources.
Before you start
The following equipments are essential to setup the ENH202:
1. One Computer/Notebook and internet accessible.
2. Two Ethernet Cables.
3. One EnGenius device – ENH202.
The equipments listed above are only for setup the ENH202, you will need more
equipment to connect the internet and it is depend on your internet network structure. You
may refer to the chapter 2 for more information.

About This Document

__________________________________________________