Wds Link Settings - EnGenius ENH202 User Manual

6.5 WDS Link Settings

WDS Link Settings is used to establish a connection between Access Points but the device is
not losing Access Point function. AP has WDS function can extend the wireless coverage and
allow LANs to communicate each other.
MAC Address
Mode
Accept / Cancel
Accept does not compile the changes, you must go to Status -> Save/Load to apply the new
settings. Please refer to the chapter 4.1 for more detail.
The Access Point that you would like to extend the wireless area must enter your Access
Point's MAC address. Not all Access Point supports this feature.
Enter the Access Point's MAC address that you would like to
extend the wireless area.
Select Disable or Enable from the drop down list.
Press Accept to confirm the changes or Cancel to return previous
settings.