Ipoa Wan Connection Setup; Igmp Multicast; Figure 28 Advanced Setup > Wan > Add (3: Ipoa); Table 17 Advanced Setup > Wan > Add (3: Ipoa) - ZyXEL Communications P-663H-51 User Manual

5.13 IPoA WAN Connection Setup

When you select IPoA in the second WAN setup add (or edit) screen, this screen displays next.
Use this screen to configure IPoA connection settings.
Figure 28 Advanced Setup > WAN > Add (3: IPoA)
The following table describes the labels in this screen.
Table 17 Advanced Setup > WAN > Add (3: IPoA)
LABEL
WAN IP Address
WAN Subnet Mask
Use the following
default gateway
Use the following
DNS server
addresses
Back
Next

5.14 IGMP Multicast

Traditionally, IP packets are transmitted in one of either two ways - Unicast (1 sender - 1
recipient) or Broadcast (1 sender - everybody on the network). Multicast delivers IP packets to
a group of hosts on the network - not everybody and not just 1.
P-663H-51 User's Guide
DESCRIPTION
Enter the IP address from the ISP. Use dotted decimal notation (like 192.168.1.1
for example).
Enter the subnet mask from the ISP. Use dotted decimal notation (like
255.255.0.0 for example).
The default is a neighboring router that helps the ZyXEL Device forward traffic to
its destination. Select this option and enter the gateway's IP address or select
the WAN interface to use to connect to it.
The ZyXEL Device uses a DNS server to resolve a domain name (find the
numeric IP address associated with the domain name). Select this option. Enter
the DNS server addresses from the ISP in the fields below.
Click this to return to the previous screen.
Click this to go to the following screen.
Chapter 5 WAN Setup
63