ZyXEL Communications P-663H-51 User Manual page 96

Chapter 9 Quality of Service (QoS)
Table 38 QoS Class Configuration (continued)
LABEL
Rule Status
Assign
Classification
Queue
Assign
Differentiated
Services Code
Point (DSCP) Mark
Mark 802.1p if
802.1q is enabled
Physical LAN Port
Protocol
Differentiated
Services Code
Point (DSCP)
Check
IP Address/
Vendor Class ID
(DHCP Option 60)/
User class ID
(DHCP option 77)
Source Subnet
Mask
UDP/TCP Source
Port (port or
port:port)
Destination IP
Address
Destination Subnet
Mask
UDP/TCP
Destination Port
(port or port:port)
Source MAC
Address
Source MAC Mask
Destination MAC
Address
Destination MAC
Mask
802.1p Priority
Save/Apply
96
DESCRIPTION
Select whether or not the classifier is to be active.
Select the QoS queue the ZyXEL Device uses for the packets of upstream traffic
that match this QoS classifier.
Select the DSCP mark the ZyXEL Device assigns to the packets of upstream
traffic that match this QoS classifier.
Select the IEEE 802.1p mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier. This only applies when IEEE
802.1q is enabled. You enable IEEE 802.1q by enabling VLAN multiplexing in
the WAN screens (see Section 5.4 on page
Select the source Ethernet port of the traffic.
Select the type of packets.
Select the DSCP mark to check upstream traffic for.
Select whether to check for a source IP address, vendor class ID, or user class
ID. Then specify the source IP address, vendor class ID, or user class ID.
Specify the subnet mask of the device that sent the traffic.
This is the port number that a device used to send the traffic.
Specify the IP address of the device that the traffic is going to.
Specify the subnet mask of the device that the traffic is going to.
Specify the port number on a device to which the traffic is going.
Specify the MAC address of the device that sent the traffic.
Specify the MAC address subnet mask of the device that sent the traffic.
Specify the MAC address of the device that the traffic is going to.
Specify the MAC address subnet mask of the device that the traffic is going to.
Specify the IEEE 802.1p mark on the traffic.
Click this button to save the changes and have the ZyXEL Device start using
them.
54).
P-663H-51 User's Guide