Error Messages - Denon AVR-1713 Owner's Manual

Error messages

NOTE
• An error message is displayed if Audyssey ® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the
necessary measures. Then perform Audyssey ® Setup again.
• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
• Be sure to turn off the power before checking speaker connections.
Examples
Audyssey Setup
MultEQ XT
C aution!
Mi crop hone or Spea ke r is none
P le ase c heck the cab le co nn ect ion
and retry.
Retry
Audyssey Setup
MultEQ XT
C aution!
A mb ient noi se is to o hig h o r lev el is
too low
Retry
Audyssey Setup
MultEQ XT
Speaker Not found Error...
Front R
P le ase c heck the cab le
c onnection and re try .
Retry
Audyssey Setup
MultEQ XT
Speaker Phase Error...
Front R
P le ase c heck the c able
c onnection and r et ry.
Retry Phase Info. Skip
Error details
• The connected setup microphone is broken, or a device other than the
supplied setup microphone is connected.
• Not all speakers could be detected.
• A front speaker (left) was not properly detected.
• There is too much noise in the room for accurate measurements to be
made.
• Speaker or subwoofer sound is too low for accurate measurements to be
made.
• The displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot be
detected.)
• The displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front right
speakers are reversed.)
• Connect the included setup microphone to the SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers are
facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, use
to select "Skip", then press
25
Set up speakers (Audyssey ® Setup)
Measures
o p
ENTER
.