Projector Name; Password - Panasonic PT-VW435NU Operating Instructions Manual

Set [EAP], [USER NAME],
and [PASSWORD].
EAP
USER
NAME:
PASS
WORD:
Æ
1: "Glossary" ( page 117 – 118)

Note
If you are unable to connect to the wireless LAN
z
through the access point even after performing the
steps in "Projector settings (
manufacturer of the access point.
When using EAP, the projector needs to be set according
z
to the setting of the RADIUS server. Check with the
network administrator for the setting of the RADIUS
server.
When using an EAP together with an access point with
z
invalid SSID broadcast, select WAP-EAP or WAP2-EAP
for the authentication method even if the authentication
method of the access point is WPA-EAP/WPA2-EAP.
Default settings of [USER 1] - [USER 3]
„
The following settings as [USER1] - [USER3] in the
wireless LAN are set before the projector leaves the
factory.
SSID
DHCP
IP address
Subnet mask
: Select the EAP

1
setup in the
RADIUS server
. Types of
 1
EAP that can be
selected are as
follows.
PEAP (MS-

1
CHAPv2 ),

1
PEAP (GTC
 1
),
 1
EAP-TTLS
(MD5 ),
 1  1
EAP-TTLS
(MS-CHAPv2

1
), EAP-FAST

1
(MS-CHAPv2
 1
), EAP-FAST
 1
(GTC )
 1  1
Input a user
name used for
authentication
(excluding
spaces)
(maximum 64
characters).
Input a

password

used for
authentication
(maximum 64
characters).
Æ page 76)", contact the
Panasonic Projector
Off
192.168.11.100
255.255.255.0
Default gateway
Mode
Authentication
Encryption
Channel
DNS 1/DNS 2
5 ) Press ▲ ▼◄► to select [Set], and press
<ENTER> button.
Save the current network settings
Note
When configuration is completed, you need to select [Set]
z
and press the <ENTER> button. At this point, select [Back]
to go back to the previous screen (2/3), or select [Cancel]
to cancel the configuration change.
Sending image from iPad / iPhone /
„
iPod touch
By using the dedicated application, you can send the
PDF file or the JPEG image which stored on your iPad
/ iPhone / iPod touch to the projector for projecting.
For details, please enter the following URL.
http://panasonic.net/avc/projector/

Projector name

You can change the projector name to be displayed
on the network.
1 ) Press ▲ ▼ to select [Projector name],
and press <ENTER> button.
2 ) Select characters with the ▲ ▼◄►
buttons and press the <ENTER>
button to enter the projector name.
Select [BS] to delete one character selected
with the cursor in the input box and press the
<ENTER> button.
3 ) Select [Set] with the ▲ ▼◄► buttons
and press the <ENTER> button.
Select [Cancel] to undo the changes and then
press the <ENTER> button.
4 ) Select [YES] or [No] with the ▲ ▼
buttons and press the <ENTER>
button.
Note
[Name ] (
z
before the projector leaves the factory.
Network
192.168.11.1
AD HOC
OPEN
NONE
11
NONE
is four-digit number) is set
ENGLISH -
71