Video Delay Control; Filter Counter; Emulate; Default - Panasonic PT-VW435NU Operating Instructions Manual

Setting
*3 : When using the projector in the elevation of
above 2 000 m and below 2 700 m, make sure
[Fan control] is set to [On 2].
Note
Failure to set the running speed of cooling fans
z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].
z

Video delay control

This function allows you to make a digital processing
of a projected image faster.
1 ) Press ▲▼ to select [Video delay
control] and then Press the <ENTER>
button.
2 ) Press ▲▼ to select one item between
[On] and [Off].
Note
[Noise reduction] and [Progressive] can not be
z
selected when [Video delay control] function is set
to [On].

Filter counter

This function is used to set a frequency for the filter
replacement.
1 ) Press ▲▼ to select [Filter counter].
2 ) Press ►or the <ENTER> button to
access the submenu items.

Filter counter

J
Show the total accumulated time of the filter use timer
setting.
Timer
J
To set a timer. When the projector reaches the
selected time the filter warning icon appears on the
screen.
1 ) Press ▲▼ to select [Timer] and then
press the <ENTER> button.
2 ) Press ▲▼ to set the Timer.
Select from [Off/1000H/2000H/3000H/
z
4000H/5000H/6000H] depending on the use
environment.
Filter counter reset
J
After replacing the filter, be sure to reset the timer.
1 ) Press ▲▼ to select [Filter counter
reset].
64
- ENGLISH
2 ) Press the <ENTER> button.
[Filter counter Reset?] appears. Select [Yes]
z
to continue. Another confirmation dialog
box appears, select [Yes] to reset the [Filter
counter].

Emulate

When using the control commands for one of our
projectors that you have previously purchased to
control this projector using a computer via its serial
input terminal, set up the [Emulate] function as
follows. This will allow you to use the control software
etc. designed for our existing projectors.
1 ) Press ▲▼ to select [Emulate].
2 ) Press the <ENTER> button or the ►
button.
The [Emulate] screen appears.
z
3 ) Press ▲▼ to select the required item.
4 ) Press the <ENTER> button.
Note
Refer to "Serial terminal" (
z
VW430 series, VX500 series,

Default

VW435N series, VX505N series
D3500 D3500 series
D4000 D4000 series
D5500 series,
D/W5k
DW5000 series, D5600 series,
series
DW5100 series, D5700 series
D5000 series, D6000 series,
DW6300 series,
DZ6700 series,
D/W/Z6k
DZ6710 series,
series
DZ570 series,
DW530 series,.
DX500 series
L520 series,
L730
L720 series, L730 series
L780 L750 series, L780 series
L735
L735 series
page 105)
Æ