Panasonic PT-VW435NU Operating Instructions Manual page 22

About Your Projector
(14) <POINTER> Button
Act as the On-Off switch for the Pointer.
( page 39)
Æ
(15) <PAGE UP/DOWN> Buttons
Scroll back and forth the pages on the screen
when giving a presentation. To use these buttons,
connect the projector and your computer with a
USB cable.(
Æ
(16) <MUTE> Button
Mute the sound. (
(17) <D.ZOOM +/-> Buttons
Zoom in and out the images. (
(18) <FREEZE> Button
Pause the projected image and sound tentatively.
( page 40)
Æ
(19) <AV MUTE> Button
Temporarily turn off the image on the screen.
( page 41)
Æ
(20) <SCREEN> Button
Select a screen mode. (
(21) <P-TIMER> Button
Operate the P-timer function. (
(22) <LAMP> Button
Select a lamp mode. (
(23) ON/OFF switch
When using the remote control, set this switch to
"ON". Set it to "OFF" for power saving when it is
not in use.
22
- ENGLISH
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
page 39)
page 40)
Æ
page 40)
Æ
page 54)
Æ
page 41)
Æ
page 41)
Æ
(25)
(24)
(23)
(24) Input Selection buttons: <COMPUTER 1>,
<COMPUTER 2>, <VIDEO>, <S-VIDEO>,
<HDMI>, <NETWORK>.
These buttons are used to select the input signal.
( page 40)
Æ
(25) <KEYSTONE> Button
Correct keystone distortion. (
Attention
Do not drop the remote control.
z
Avoid contact with liquids.
z
Do not attempt to modify or disassemble the remote
z
control.
Note
The remote control can be used within a distance of
z
about 7 m (22.97 ft) if pointed directly at the remote
control signal receiver. The remote control can control at
angles of up to ± 30 ° vertically and ± 30 ° horizontally,
but the effective control range may be reduced.
If there are any obstacles between the remote control
z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reflecting the remote
z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a
z
fluorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
page 39)
Æ