Panasonic PT-VW435NU Operating Instructions Manual page 91

CAUTION on Handling and Storing the USB thumb drive
 Do not put USB thumb drive or its cap within close reach of children. Swallowing them may cause
suffocation.
 If the smoke or questionable odor rise, turn off the peripheral equipment and contact yourdealer.
 Do not put water, chemical or oil to the USB thumb drive. It may cause short out or fire.
 Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or
data corruption.
 Do not remove the USB thumb drive from the computer or the projector while the USB thumb drive is
reading out or writing the data. It may cause data loss or data corruption.
 Do not store the USB thumb drive where high temperature, humid or dusty place or magnetizeditems are
around.
Direct start-up into the memory viewer mode
J
"Network", and then an image stored in the root directory of the USB thumb drive is displayed on the screen.
* If the image file is not available in the root directory of the USB thumb drive, the memory viewer browser
window appears.
* When the projector is turned off and on while the USB thumb drive is left inside in the memory viewer
mode, the projector starts into the memory viewer mode and an image stored in the USB thumb drive is
displayed on the screen.
When you press <AUTO SETUP/CANCEL> button in the memory viewer mode, the memory viewer browser
window as shown on page 92 appears on the screen.
When you remove the USB thumb drive during operating the projector in the memory viewer mode,
the input source returns to the previous one selected just before inserting the USB thumb drive.
AUTO SETUP/CANCEL
button
Note
 During accessing to the USB thumb drive, do not turn off the power or eject the USB thumb drive because the
data in the USB thumb drive might get damaged. During accessing, the USB thumb drive is blinking.
 The USB thumb drive allows you to insert or remove regardless of the power status of the projector.
 The direct start-up into the memory viewer mode may not operate when the USB thumb drive is inserted
immediately after being removed.
 During in [Multi live] mode of "Wireless Manager ME6.0", the direct start-up into the memory viewer mode is
not available. After terminating [Multi live], insert the USB thumb drive, or operate "Memory viewer" (
73).
Remote Control
Network
page
Æ
91
ENGLISH -