Memory Viewer Function - Panasonic PT-VW435NU Operating Instructions Manual

Network

Memory Viewer function

The Memory Viewer function is to make a presentation or project an image without using computers or some
other external equipment. You do not have to carry a computer or other equipment to project images.
Store images on a dedicated USB (Universal Serial Bus) thumb drive and insert it into the USB port (Series A) of
the projector, then you can project those images.
Which images can be projected with the Memory Viewer function?
With the Memory Viewer function, you can project images in these formats below.
• Bitmap data
• JPEG data
• Text data
JPEG data used with Memory Viewer
Memory viewer does not support the resolution of image greater than 8191 x 8191 pixels.
Text data used with Memory Viewer
Memory viewer supports the text file with the ASCII format for single byte. Other text formats cannot
be supported.
Back up the data
It is recommended that important data to edit with Network Viewer (See Wireless Manager mobile edition 6.0)
and store in USB thumb drive should be stored in other media in advance. We are not responsible for any
data losses or damages resulting from use of the Memory Viewer function.
USB thumb drive for the Memory Viewer function
J
Commercially available USB thumb drives can be used for this Memory Viewer function.
The USB port is compatible with USB thumb drive formatted with FAT16 or FAT32.
It is not compatible with other formats. Please note that when you format the USB thumb drive.
Inserting the USB thumb drive
J
Insert the USB thumb drive directly into the USB port on the rear terminal of the projector as shown in the
figure below.
COMPUTER 1 IN COMPUTER 2 IN
MONITOR OUT
VIDEO IN AUDIO IN
SERIAL IN
L
CAUTION on insertion and removal of the USB thumb drive
Please note following points to insert and remove the USB thumb drive.
 The indicator of the USB thumb drive will be blinking when it is inserted to the projector or while the
projector is reading out the data. Do not remove the USB thumb drive while it is blinking.
 When using a USB thumb drive without indicator, you cannot recognize when the projector reading out
the data. Please remove it from the projector after closing the memory viewer function or turning off the
projector.
 Do not install and remove the USB thumb drive frequently. Remove the USB thumb drive at least 5 seconds
after installation. And install at least 5 seconds after removal. While installing or removing the USB thumb
drive, the projector is in switching period for those operation.
90
- ENGLISH
USB port (Series A)

USB B USB A
VIEWER
DISPLAY/
MOUSE CONTROL
MIC IN
COMPUTER VARIABLE
R
AUDIO IN AUDIO OUT
LAN

S-VIDEO IN
USB thumb drive
Note:
When inserting, confirm the
direction of the plug not to
damage the terminal.