Regarding The Indicator Lamps - Hitachi CP-WX3014WN Operating Manual

Regarding the indicator lamps

When operation of the
check and cope with it according to the following table.
Lighting Turned
In
Blinking
Turned
In
Green
Lighting Turned
In
Blinking
Turned
In
Orange
Blinking
(discre-
In
Red tionary)
Blinking
In
Red
Lighting
or
In
Lighting
In
Blinking
In
Red
Blinking
or
In
Red
Lighting
In
Blinking
In
Turned
or
Lighting
In
(continued on next page)
, and
Turned
Please refer to the section "Power on/off".
Turned
Please wait.
Turned
Ordinary operations may be performed.
Turned
Please wait.
(discre-
Please wait until
tionary)
and then perform the proper measure using the item
descriptions below.
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
sufficiently cooled down, please make confirmation of
Turned
the following items, and then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air filter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the remedy,
please change the lamp referring to the section
Please turn the power off, and allow the projector to
cool down at least 45 minutes. After the projector has
Turned sufficiently cooled down, please make confirmation of
the attachment state of the lamp cover. After performing
any needed maintenance, turn the power on again.
If the same indication is displayed after the remedy,
please contact your dealer or service company.
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
Blinking
sufficiently cooled down, please make confirmation
In
that no foreign matter has become caught in the fan,
Red
etc., and then turn the power on again.
If the same indication is displayed after the remedy,
please contact your dealer or service company.
Troubleshooting
indicators differs from usual,
indicator finishes blinking,
.
101