Installing An Optical Drive - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

7. Press down on the green drive retainer button located on the left side of the drive to disengage the
drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it
stops, then lift it up and out of the drive cage (2).
Figure 5-13
8. If you are replacing the drive, transfer the four guide screws from the old drive to the new one.

Installing an optical drive

To install or re-install an optical drive:
1. Follow the procedures listed in the
CAUTION:
data loss.
2. Remove the access panel (see
3. Remove the front bezel (see
4. If necessary remove the bezel blank. (See
82 Chapter 5 Replacing components
Removing the optical drive
Predisassembly for drives on page 77
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page 72).
Remove bezel blanks on page
section.
71).
78).
ENWW