Removing A Dimm - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Removing a DIMM

To remove a DIMM:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. Rotate the drive cage to its upright position.
Figure 5-45
4. Push gently outward on the DIMM socket levers (1) as shown in the following figure.
Figure 5-46
5. Lift the DIMM straight up (2) and out of the socket, then store the DIMM in an antistatic bag.
ENWW
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Rotating the drive cage up
Removing a DIMM
Predisassembly procedures on page
71).
Removing and installing components 107
68.