HP Z200 - Small Form Factor Workstation Maintenance And Service Manual page 172

Table 6-9 POST error messages (continued)
Screen message
919—Multi-Bay Riser Not
Connected
920—Fatal error on QPI link X Fatal error detected on QPI link x,
921—Fatal error on QPI
Protocol link X
922—Fatal error on PCIe slot
X
923—Fatal error on ESI port 0 A fatal error occurred on ESI port 0.
924—Fatal error on IOH core
X
925—Fatal error on IOH
miscellaneous
926—Fatal error on IOH Vtd
927—Fatal error on DIMM in
slot CPU X DIMM Y
928—Fatal machine check
detected on CPU X
1720—SMART Hard Drive
Detects Imminent Failure
1783—Fixed Disk 0/1 locked
1796—SATA Cabling Error
1797—SATA Drivelock is not
supported in RAID mode
1801—Microcode Update
Error
1802—Processor Not
Supported
160 Chapter 6 Diagnostics and troubleshooting
Probable cause
Multi-Bay riser mechanism is missing
or is not connected.
where x is 0 or 1. This type of error is
identified on the line following the error
message.
Fatal error detected in QPI link x
protocol, where x is 0 or 1. This type of
error is identified on the line following
the error message.
Fatal error occurred in the designated
slot.
slot.
Fatal error detected on IOH core x,
where x is 0 or 1. This type of error is
identified on the line following.
Fatal miscellaneous error detected on
IOH core x, where x is 0 or 1.
Fatal error detected in the Intel
Virtualization Technology.
Fatal multibit ECC error detected on
the DIMM in the slot labeled DIMM x
(where x is 1 - 4), as labeled on the
system board.
Hard drive is about to fail. (Some hard
disk drives have a firmware patch that
fixes erroneous error messages.)
Hard disk drive failure.
Missing or improperly attached cable.
SATA Drivelock is not supported in
RAID mode.
Unknown or unsupported processor
stepping.
The system board does not support the
processor.
Recommended action
1. Replace or reconnect the missing Multi-Bay
mechanism to the system board.
2. Reseat or replace the missing mechanism cable.
Potential system board problem; contact HP Support.
Potential system board problem; contact HP Support.
Move the card to a different slot. If the problem persists,
replace the card.
Verify that the ESI port device is connected and working
properly.
Potential system board problem; contact HP Support.
Potential system board problem; contact HP Support.
Potential system board problem; contact HP Support.
Replace the DIMM in the identified slot.
Contact HP support.
1. Determine if the hard disk drive is giving a correct
error message.
2. Run the Drive Protection System test (if
applicable).
3. Apply firmware patch (if applicable).
See http://www.hp.com/support.
4. Back up contents and replace the hard disk drive.
Diagnose the hard disk drive, and replace it if
necessary.
Verify that a cable is attached. Reattach the cable.
Disable RAID mode, or disable SATA drivelock..
The microcode update failed. Check the processor
stepping to ensure it is a supported stepping. If it is
contact, HP Support.
Replace the processor with a compatible one.
ENWW