Saving And Printing Information In Hp Vision Diagnostics; Diagnostic Codes And Errors; Diagnostic Led And Audible (Beep) Codes - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Saving and printing information in HP Vision Diagnostics

You can save the information displayed in the HP Vision Diagnostics Survey, History and Errors tabs
to a diskette or a USB flash drive. You can not save to the hard drive. The system will automatically
create an html file that has the same appearance as the information displayed on the screen.
1. Insert a diskette or USB flash drive if running HP Vision Diagnostics from CD.
2. Click Save in the bottom on any of the Survey, History or Errors tabs. All three log files will be saved
regardless of from which tab the Save button was clicked.
3. Select the drive onto which you will save the log files and click the Save button. Three html files
will be saved to the inserted diskette or USB flash drive.
NOTE:
files have been written to the media.
4. Print the desired information from the storage device used to save it.
NOTE:
screen. Be sure to remove the USB flash drive or CD from the optical drive.

Diagnostic codes and errors

This section presents information about diagnostic LED codes, LED color definitions, and POST error
messages to help you troubleshoot problems.

Diagnostic LED and audible (beep) codes

This section describes the front panel LED error and operation codes as well as the audible codes that
might occur before or during the POST.
Table 6-7
Activity
Blue Power LED
beeps.
Blue Power LED
every two seconds.
beeps.
Blue Power LED
beeps.
Blue Power LED
three times*, once per
second. * No beeps.
Blue Power LED
times*, once per second.
beeps.
*User-selectable. See
menu on page 32
For the following LED activity and beeps, the beeps are heard through the chassis speaker. Blinks and beeps repeat for 5 cycles, after
which, only the blinks continue to repeat.
152 Chapter 6 Diagnostics and troubleshooting
Do not remove the diskette or USB key until you see a message indicating that the html
To exit HP Vision Diagnostics, click the Exit Diagnostics button at the bottom of the
Diagnostic lights and audible codes
Possible cause
* on. No Computer on.
blinks Computer in Sleep mode
*
* No (S3-Suspend to RAM).
Select models only.
* is off. * No Computer in Hibernate
mode (S4-Suspend to disk)
or system is off (S5).
* blinks Computer in Sleep mode
(S3-Suspend to RAM).
Select models only.
* blinks four Computer in Hibernate
* No mode (S4-Suspend to disk).
The Computer Setup (F10) Utility
for details.
Recommended action
N/A
ENWW