Removing And Replacing The Primary Hard Drive - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

5. Place the drive's guide screws into the J-slots in the drive bay. Then slide the drive toward the front
of the computer until it locks into place.
TIP:
Figure 5-22
6. Connect the drive cables:
a.
b.
7. Replace the optical drive. (See
8. Replace the front bezel (see
9. Replace the access panel (see
10. Restore all connections and equipment that you removed during the
on page

Removing and replacing the primary hard drive

The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard
drive:
1. Follow the procedures listed in the
CAUTION:
data loss.
2. Remove the access panel (see
3. Remove the front bezel (see
88 Chapter 5 Replacing components
Angle the drive toward one side of the chassis to line up the guide screws with the slots.
Installing a drive into the drive cage (media card reader shown)
If installing a second hard drive, connect the power and data cables to the rear of the drive
and connect the other end of the data cable to the next available (unpopulated) SATA
connector on the system board by following the numbered sequence of the connectors.
If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled MEDIA. If the media card reader includes a 1394
port, connect the 1394 cable to the 1394 PCI card.
NOTE: See Locate system board drive connections on page 78
system board drive connectors.
68.
Failure to follow the predisassembly procedures can result in equipment damage or
Installing an optical drive on page
Installing the front bezel on page
Installing the access panel on page
Predisassembly for drives on page 77
Removing the access panel on page
Removing the front bezel on page
for an illustration of the
82.)
72).
71).
Predisassembly procedures
section.
71).
72).
ENWW