Eisa/Gsc Slots From Inside The Eisa Assembly - HP Visualize J5000 - Workstation Service Handbook

graphics0 Graphics device in slot0. If using a Dual Graphics Card, this is the
port to the right on the card when facing the back of the workstation.
graphics1 Graphics device in slot1. If using a Dual Graphics Card, this is the
port to the right on the card when facing the back of the workstation.
graphics2 Graphics device in slot2. If there is a Dual Graphics Card in slot1,
this is the port to the left on the card when facing the back of the
workstation.
graphics3 This is a logical slot, and can only be reached by using the left port
of a Dual Graphics Card in physical slot0.
NOTICE: We do not recommend using a Dual Graphics Card in
slot2, other than the CRX/HCRX. If running 9.05,
you can only use a maximum of 2 graphics cards,
with the exception of using the dual graphics card. If
using the dual graphics card, it must be the only card
in the system and be physically located in slot0
The following illustrations show the physical layout of the EISA/GSC slots, first
from inside the EISA Assembly (Figure 9–1), then from outside the system unit (Fig-
ure 9–2).
Figure 9–1. EISA/GSC Slots from Inside the EISA Assembly
Boot Console 9–7