Figure 4-4. Emi Cover For The Cd Drive - HP Visualize J5000 - Workstation Handbook

CD Drive (Optional)
This subsection describes how to remove and replace the optional CD drive.
Removing a CD Drive:
1. Remove the front panel bezel and the top panel from the workstation.
2. In the top, right front of the workstation above the CD drive bay, remove the EMI
(electromagnetic interference) cover that is held in place by tabs. The EMI cover is
shown in Figure 4-4.

Figure 4-4. EMI Cover for the CD Drive

EMI cover
3. From the top of the workstation, reach behind the CD drive and disconnect the audio
cable, power cable, and ATAPI interface ribbon cable from the rear of the CD drive.
4. Remove the two T-15 Torx screws securing the CD drive to the front panel of the
workstation chassis.
5. Slide the CD drive carrier assembly out of the chassis guide rails.
6. To remove the CD drive from the carrier, remove the four T-10 Torx screws (two on each
side) securing the CD drive to the carrier.
Replacing a CD Drive:
NOTE See the section titled "CD Drive (Optional) Configuration" on page 35 for
information about configuring a CD drive for installation.
1. Remove the front panel bezel and the top panel from the workstation.
2. In the top, right front of the workstation above the CD drive bay, remove the EMI
(electromagnetic interference) cover that is held in place by tabs. The EMI cover is
shown in Figure 4-4 above.
3. If you are installing a new CD drive into the empty CD drive bay:
a. Remove the two T-15 Torx screws securing the CD drive carrier to the front panel of
the workstation.
b. Slide the CD drive carrier out of the chassis guide rails.
c. Remove the filler panel from the CD drive carrier as shown in Figure 4-5 on the next
page.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
93