HP Visualize J5000 - Workstation Handbook page 69

Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
FLT 7890 DIMM
FLT 7891 DIMM
FLT 7892 SYS BD
FLT 7893 SYS BD
FLT 7900 SYS BD
FLT 7901 SYS BD
FLT 7902 SYS BD
FLT 7903 SYS BD
FLT 7904 SYS BD
FLT 7905 SYS BD
FLT 79FF SYS BD
WRN 80F3 SYS BD
WRN 80F4 EXT IO
WRN 80F5 EXT IO
WRN 80F6 EXT IO
WRN 80F7 EXT IO
WRN 80F8 EXT IO
WRN 80FC EXT IO
INI 8800 IOCARD
INI 88 r 1 IOCARD
INI 8802 IOCARD
INI 8803 SYS BD
INI 8804 SYS BD
Chapter 3
Message
MBE overwrt SBE
dup entry in PDT
PDT write error
PDT is full
no DMT entry
no rank entry
bad refrsh intvl
mem intrlv fail
mem reloc failed
mem intrlv error
mem firmware err
err rd IODC byte
boot read error
boot exec error
boot read error
boot IO error
invalid boot dev
invalid boot dev
PCI BusWlk start
PCI Rope r walk
PCI BusWalk done
PCI alloc done
PCI config done
Identifying LCD-Indicated Conditions
Description
Firmware replaced a correctable memory
error entry in the PDT with an
uncorrectable memory error entry at the
same address.
The PDT already contains an entry at
that address.
Error adding the entry to the PDT.
The PDT is full--cannot add new entry.
Internal error--cannot find DIMM entry.
Internal error--cannot find rank entry.
Computed refresh interval is invalid.
Cannot generate memory interleave.
Cannot interleave with relocated range
(3.75GB - 4.0GB).
Undefined memory interleave failure.
Internal error--never expected this to
happen.
Cannot read IODC from ROM or card.
Cannot load IODC entry_init for boot
device.
Error initializing boot device.
Cannot load IODC entry_io for boot
device.
Error detected during boot device I/O.
Invalid boot device class; bad IODC?
Unexpected error; bad IODC?
Starting PCI bus and device discovery.
Starting PCI bus and device discovery on
Rope r.
PCI bus and device discovery complete.
Done allocating address space for PCI
devices.
Done configuring PCI devices.
Troubleshooting
65