HP Visualize J5000 - Workstation Handbook page 78

Troubleshooting
Identifying LCD-Indicated Conditions
Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
INI CC0 n SYS BD
INI CC1 n SYS BD
INI CC2 n SYS BD
INI CC3 n SYS BD
INI CC4 n SYS BD
TST D000 SYS BD
WRN D004 SYS BD
INI D005 SYS BD
INI D006 SYS BD
WRN D007 SYS BD
FLT D01 n SYS/IO
D02 n
WRN SYS/IO
74
Message
CPU n OS rendezvs
CPU n early rend
CPU n rendezvous
CPU n cache rend
CPU n mem rendez
micro controller
micro not resp
set dom1 fan spd
set dom2 fan spd
bad microctl cmd
fan n : failure!
fan n : too slow!
Description
Slave CPU n entering the final
rendezvous, waiting for the operating
system to awaken it.
Slave CPU n entering the early
rendezvous, waiting for the monarch CPU
to initialize scratch RAM and other
system state.
Slave CPU n entering rendezvous. Slave
CPUs enter this rendezvous numerous
times during boot.
Slave CPU n entering cached rendezvous,
waiting for the monarch CPU to configure
the system bus.
Slave CPU n entering memory
rendezvous, waiting for the monarch CPU
to select a boot device.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware is initializing communications
with the system controller.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware detected system fan n stopped.
Firmware detected system fan n is
running too slowly.
Chapter 3