IBM NetVista Hardware Maintenance Manual page 60

any additional software from the hard disk
drive before you reload the software.
How to Diagnose Combined FRUs: If an adapter or
device consists of more than one FRU, any of the
FRUs might cause an error code. Before replacing
the device or adapter, remove the FRUs one by one
to see if the symptoms change.
If a newly replaced FRU does not correct the
problem: If you have reached this point of the check
procedures and were instructed to replace a FRU but
doing so did not correct the problem, reinstall the
original FRU and go through "Start" again.
If you want to print a copy of a Configuration/Setup
Utility screen to an attached printer, press Print
Screen key while the following screen is displayed.
READ THE FOLLOWING:
Human Error is a cause for concern when applied
to check procedures. It exists in every first time
set of analysis procedures. It is therefore
essential for effective and time-efficient servicing
that each stage of every procedure be verified.
(For example: When a symptom is found, or when
a symptom appears to have been cured; the
preceding steps should be repeated for accuracy
of analysis.)
001 - START
•
To begin, note the following:
•
Disable the setting of "Fast POST Mode" in
Configuration/Setup Utility.
•
To disable or reset the power-on password, see
"User Password" on page 10.
•
Disconnect all external cables and devices
including speakers and microphone from the
system unit, except for the keyboard, mouse, and
monitor.
•
Power off the system unit (unplug the power cord)
before moving it or when replacing FRUs.
•
Remove all adapter cards, except for the factory-
installed modem adapter card and any other IBM
Personal Computer factory-installed adapter
cards.
•
Disconnect all drives except:
28 IBM Desktop System HMM